RDL DS-J1 Microphone Input Assembly - XLR, Terminal block (Stainless) - Custom Engraving OptionThe D SERIES J1 is a complete microphone input panel assembly. Connections to the female front? panel XLR jack are made on a rear barrier block. Four terminals are provided: CASE GROUND, SHIELD (XLR pin 1), + (XLR pin 2) and (XLR pin 3). The installer may install a jumper between the SHIELD connection and CASE GROUND if desired. The back of the D SERIES J1 is finished with a metal enclosure clearly labeled for easy installation. The D SERIES J1 fits

Up to 42 MHz bandwidth with 1680 selectable frequencies

The ultra compact RX200 isn't only small

the Direct-Drive is made to handle the rigors of professional touring with 14-gauge steel throughout

This stand lifts up the speaker from the table

The -RC4M operates from the same power supply as the selector

quality and precision at every stage

Signal-activated paging channel automatically mutes background music

high temperature 75 mm (3 in) voicecoil and reduced distortion through saturatedgap magnet geometry

25" (64 mm) drivers mounted in a vertical line array deliver wide horizontal coverage with narrow vertical pattern control

CK43 and CK49)

"Clean" to "Saturated" tube sounds

which fits onto the base of the mic